Kukel International Group Limited
Categories
Home > Exhibition > Content

Leakage treatment of faucets

Kukel International Group Limited | Updated: Apr 28, 2018

Leakage treatment of faucets


In the ordinary life, sometimes the water of the faucet will still drip after being tightened, and it will be dropped from the outlet of the faucet or the joint, which will not only cause a lot of waste, but sometimes it will cause some problems. . In fact, the construction of the faucet is very simple, and the maintenance of the leakage can be completely repaired by yourself. In general, the problem of water leakage can be changed by replacing the components such as the axial washer or the triangular gasket of the faucet. has been solved. However, you have to turn off the main faucet switch of your home before you can do the renovation.


With regard to leak repair at the faucet joint, the cause of water leakage is nothing more than the damage of the sealing tape of the tap part (fixing screw). So just use a wrench to remove the faucet and re-roll the new sealing tape in place of the fixing screw. Here are the maintenance steps: First, tighten the faucet first and use a wrench to turn the faucet counterclockwise. Swing removed. Second, place the threaded hole outwards and use the wind-print tape to wind 5-6 times on the threaded portion. To see if the faucet has been adjusted, use a water-saving wrench to clockwise. After the final installation, open the main switch and check to see if there is any leakage.


Contact Us
Address: Room 11, 8/F, Block B, Hi –Tech Industrial Centre, 491–501 Castle Peak Road, Tsuen Wan, New Territories, Hong Kong
Tel: 852-28388323
Fax:852-23868438
E-mail:william@kukel.com
Copyright © Kukel International Group Limited All Rights Reserved.
Share: