Kukel International Group Limited
Categories
Home > Exhibition > Content

How to install the basin faucet to achieve water-saving effect

Kukel International Group Limited | Updated: Apr 11, 2018

How to install the basin faucet to achieve water-saving effect



The faucet is an indispensable life essential product for the kitchen and bathroom. We cannot measure it by the size of the head. However, everything is a double-edged sword, which brings convenience and at the same time, a lot of failures occur. The failure of the faucet is not only determined by the faucet manufacturer's quality, but also by its installation module. Xiaobian specially brings you the installation skills of the faucet manufacturers. The most water-saving installation method. Have you mastered it?


Faucet manufacturers require that the installation of single-hole kitchen faucets should be stable, because the kitchen faucet is used frequently, and it is easily moved and moved away, so the lock nut must be tightened. Now there are some faucet manufacturers in the market for the spiral nut to increase the nut fixed, this stability is very good, if you can solve the problem of water to pull the future will be a popular trend.


Faucet manufacturers should pay attention to the outlet diameter when installing the basin faucet. Most of the products in the market today are hard-pipe inlets, so you should pay attention to the height of the reserved inlet, which is most suitable for down to 35 centimeters from the basin. When installing, it must be equipped with a special angle valve, and the angle valve must be fixed with the hot and cold water pipes of the wall outlet.


When you find that there is a distance between the angle valve and the water pipe on the faucet, be sure to buy a special extension pipe to connect, do not use other pipes to connect, because if the water pressure is large, it is easy to fall off, leak, and cause you loss. If the inlet pipe is longer than the outlet pipe, you can cut it off according to your needs. If the angle is not appropriate, you can bend it to your desired position. Do not hard bend to 90° or more than 90°. When installing the basin to remove water, don't forget to buy a small connector for the faucet at the tap manufacturer. Don't forget to flush the water pipe buried in the wall before you install it.


Before installing the thermostatic faucet, please check whether the water pipe is left hot and right cold. Do not connect the hot and cold water pipes to the wrong pipe to prevent the faucet from working properly. Gas and solar water heaters cannot use faucet manufacturers' thermostatic faucets because the water pressure is too low. Installing a thermostatic faucet Do not forget to install a hot and cold water filter.


Contact Us
Address: Room 11, 8/F, Block B, Hi –Tech Industrial Centre, 491–501 Castle Peak Road, Tsuen Wan, New Territories, Hong Kong
Tel: 852-28388323
 Fax:852-23868438
 E-mail:william@kukel.com
Copyright © Kukel International Group Limited All Rights Reserved.
Share: